Software Required to Build GridPACK

From GridPACK
Revision as of 19:11, 23 September 2013 by 130.20.182.70 (talk) (Created page with '= Software Required to Build GridPACK = == CMake/CTest == GridPACK uses the [http://www.cmake.org/ CMake] cross-platform build system. A reasonably modern version is required....')

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Software Required to Build GridPACK

CMake/CTest

GridPACK uses the CMake cross-platform build system. A reasonably modern version is required. Currently, version 2.6 or newer is required.

CMake projects are designed to be built outside of the source code location. If the entire GridPACK trunk repository is checked out, the top of the the CMake project is .../src. Make a subdirectory there called build or something. Configure and build GridPACK in that subdirectory.

MPI

A working MPI implementation is required. OpenMPI has been used successfully. There is no reason to think other implementations would not work. The GridPACK configuration can deal with MPI compiler wrappers (e.g. mpicc), but can also understand other installations.

Identify the compilers and mpiexec to the configuration by including cmake options like:

   -D MPI_CXX_COMPILER:STRING='openmpicxx'
   -D MPI_C_COMPILER:STRING='openmpicc'
   -D MPIEXEC:STRING='openmpiexec'

Other options may be needed to specify the MPI environment. See the documentation here.

Boost

The Boost C++ Library is used heavily throughout the GridPACK framework, and a relatively recent version is required. The configuration requires version 1.52 or later, but older versions may work. The Boost installation must include Boost::MPI which must have been built with the same MPI compiler used for GridPACK.

To configure GridPACK one need only specify where Boost is installed, like this

   -D Boost_DIR:STRING='/opt/local'


PETSc

GridPACK currently relies on the Portable, Extensible Toolkit for Scientific Computation (PETSc) for parallel linear algebra, and linear and nonlinear system solvers. PETSc is a complicated package with numerous options. PETSc needs to be built with MPI enabled and using the same MPI implementation used for GridPACK. It also needs to be configured for complex support and to use C++ as the base language. Refer to the PETSc installation documentation for hints on how this is done.

The GridPACK configuration must know where PETSc is installed. This is specified by two options as shown below.

   -D PETSC_DIR:STRING='/Users/d3g096/ProjectStuff/petsc-3.4.0'
   -D PETSC_ARCH:STRING='arch-darwin-cxx-opt'


ParMETIS

GridPACK uses ParMETIS to (re)distribute an electrical grid network over several processors. It needs to be built with the same MPI configuration as Boost and PETSc. In most cases, the GridPACK configuration just needs to know where ParMETIS was installed, which is specified by

   -D PARMETIS_DIR:STRING="/pic/projects/gridpack/software"

GridPACK requires version ParMETIS version 4.0. Older versions will not work.

Doxygen

GridPACK uses Doxygen to help document code. Doxygen documentation can optionally be prepared during the build process. This is enabled if Doxygen is found. Graphviz is necessary for full documentation features.